DESCRIPTION

INSULBOND 2741 is a two component, high impact epoxy adhesive system that has been designed for bonding metal hammer heads to metal, fiberglass, or wood handles. It has been extensively tested and is being widely used in the industry. Designed for either hand or machine mixing and application, the system is equal ratio by volume. The pot life is long enough to allow easy hand application. While heat cure is suggested, the system will achieve most of its properties in 24 to 48 hours at ambient room temperature. INSULBOND 2741 is normally supplied with the Part A colored black, although clear or other colors are available upon request.

INSTRUCTIONS FOR USE:

Mix INSULBOND 2741 Part A thoroughly before use. Weigh out equal amounts of INSULBOND 2741 Part A and Part B by volume (100:90 by weight) into a clean container. Stir the mixture thoroughly and apply as needed. A full cure will be achieved within 24 to 48 hours at room temperature. A mild heat cure of 100°C at 60 minutes will achieve the same results.

IMPORTANT:

The following supersedes any provision in your company's forms, letters and papers. AMERICAN SAFETY TECHNOLOGIES makes NO WARRANTY, WHETHER EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE FOR THIS PRODUCT. No statements or recommendations contained in the product literature are to be construed as inducements to infringe any relevant patent, now or thereafter in existence. UNDER NO CIRCUMSTANCES SHALL AMERICAN SAFETY TECHNOLOGIES BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR OTHER DAMAGES FROM ALLEGED NEGLIGENCE, BREACH OF WARRANTY, STRICT LIABILITY OR ANY OTHER THEORY, ARISING OUT OF THE USE OR HANDLING OF THIS PRODUCT. The sole liability of AMERICAN SAFETY TECHNOLOGIES for any claims arising out of the manufacture, use or sale of its products shall be to refund the buyer's purchase price, provided such products have been demonstrated in AMERICAN SAFETY TECHNOLOGIES sole opinion, to justify such refund.

HEALTH CAUTION:

Avoid breathing possible fumes, mists and vapors which can cause severe respiratory damage. Use of NIOSH approved breathing apparatus is required for more than minimal exposure. Always work in areas with adequate ventilation to allow dissipation of polyamine and other chemical fumes, and where applicable, solvent fumes. Use of goggles, protective garments, rubber gloves, protective cream is required. If material gets into eyes, flush thoroughly with clean water for twenty (20) minutes; then seek medical treatment. Avoid skin contact. Material can cause contact dermatitis. Always wash exposed areas immediately, using warm water and soap, followed by rinsing with clean water. Observe all safety precautions, It is important when using solvent based materials or solvents to keep away from open flame or ignition source.

12/98